¿Quien me traduce esto? Sin traductor de Google..

Face boards cut at 7.5 angle from nominal 2 x 6 or 5/4 x 6 stock.
Each board 1.5" longer than the one above.
Inside ends lap cut half the depth of board, width of end board (3/4").
End boards cut at 15 angle from nominal 1 x 6 above.
Must be 3/4" thickness.

Assemble with end boards in lap joint offset 3/4" below flush. Round one bottom corner of end board to make connection with adjoining section easier. Make sure to round corners on same side of section.

Hacer clic para expandir...